Receiver | Electronics Tarot Tarot Tl150F2 Rfasb 16-Ch 2.4Ghz Fasst Receiver ( For Futaba)

This Is A 2.4Ghz 16-Channel Receiver With S.Bus Port And Compatible With Futaba Fasst Protocol,

You Can Bind It With Your Futaba

6Ex / 7C / Tm-7 / Tm-8 / T8Fg / T10C / Tm-10 / T10Cg / T12Z / T12Fg / Tm-14 / T14Mz Etc Transmitter.

It’S So Small And Light Weigh (4.2G) That You Can Fit It On Palm Size Fpv Racers And Connect With Cc3D Or Clean Flight Flight Controllers.

&Nbsp;

Specification
Output Channel : 16-Channel
Output Signal : Rssi &Amp; S.Bus (1Ch~16Ch)
Port : S.Bus
Protocol : Futaba Fasst
Input Voltage : 3.5~8.4V
Servo Frame Rate : 14Ms (Fs-Normal Speed Mode) / 7Ms (Hs-High Speed Mode)
Working Temperature Range : -10-80&Sbquo;ÑÉ
Dimension : 36 X 19 X 7 Mm
Weight : 4.5G
Binding Procedures :
Turn On Your Futaba Transmitter
Press And Hold F/S Button On Receiver, And Connect Battery At The Same Time
Wait Until Red Led Turns Off And Green Led Turns Solid, That Means Binding Complete.
How To Switch Between Fast Speed (Fs) And High Speed (Hs) Mode :
Turn Off Transmitter
Connect The Battery To Receiver
Press The F/S Button On The Receiver For 6 Seconds, Then Release, The Red Led Will Flash Rapidly For Hs Mode, Or Flash Slowly For Fs Mode. Repeat This Procedure To Alternate Modes
* Warning : Hs Mode Is Only Applied For High-Speed Digital Servos.Other Servos Should Select Fs Mode Otherwise Servos Will Get Hot Or Even Burn Out.

&Nbsp;

&Nbsp;