Putty And Detailing Solutions | Accessories Microscale Micro Sol Setting Solution 29.5Ml (1Oz)

Information:
Use On The Most Difficult Irregular Surfaces To Be Found On Models. It Completely Softens The Decal, Allowing It To Drape Down Onto The Surface Of The Model, Comforming Perfectly To Surface Irregularities Without Distortion. Coat Micro Sol On For Only A Few Seconds And Then Leave It Alone. It Does The Work. Do Not Touch Until The Decal Has Dried, As The Decal Is Very Soft At This Stage And Could Be Easily Damaged. For The Best Results, First Apply Micro Sol To Prepare The Surface And Enhance The Adhesive. Make Sure The Surface Is Free Of Particles That Could Get Under The Decal’S Film And Cause A Blemish. Then, When Everything Is Dry Enough That The Decal Will Not Move Easily, Apply Micro Sol With A Small Flat Brush. Apply With As Few Strokes As Possible So A Not To Disturb The Decal. Allow The Decal To Dry. One Application Is Usually Enough, But If Necessary, A Second Application Of Micro Sol Can Be Helpful.